FBH65SB-wg Wireless motion/brightness sensor with 2 solar cells and battery


Wireless motion/brightness sensor pure white glossy for single mounting 84 x 84 x 27 mm or ­mounting into the E-Design65 switching system. With solar cells and battery (lifetime 4-5 years). Smart Home sensor.

The factory setting switches off taught-in light actuators and dimming actuators automatically if no motion is detected for 5 minutes. Switch-on is by means of the light pushbutton.
Place a jumper in ‚active‘ position to enable automatic motion-dependent switch-on. The brightness threshold at which the sensor sends a Motion telegram is set by a potentiometer.
The holding plate can be screwed to a flat surface or affixed to the ceiling or wall using the enclosed adhesive foil.
We recommend stainless-steel countersunk 2.9 x 25 mm, DIN 7982 C, for screw connections. Both with rawl plugs 5 x 25 mm and with 55 mm switch boxes. An adhesice foil and a set of 2 stainless-steel counter­sunk screws 2,9 x 25 mm and plugs 5 x 25 mm are enclosed. The wireless sensor can be taught-in into the tap-radio® actuators TF61L, TF61D, FTA65L, FTA65D, FTA55L, FTA55D, TF100L and TF100D.

EAN 4010312317914

Datasheet