Wireless temperature controller with display pure white glossy for single mounting 80 x 80 x 22 mm or mounting into the E-Design55 switching system. With solar cell and battery (lifetime 3-5 years). Smart Home sensor.
The sensor sends a message every 100 seconds to the Eltako wireless network at an actual temperature change of minimum 0.3°C. The bistable display is updated.
A change in reference temperature is sent immediately. The display is updated.
If there is no change, a status report is sent every 17 minutes.
Measurement accuracy is approx. 1°C.
Screw on the holding plate including its electronics. Then snap on the frame, remove the battery insulation, and mount the cover panel together with the display and solar cells.
We recommend stainless-steel countersunk screws 2.9 x 25 mm, DIN 7982 C, for screw connections.
Both with rawl plugs 5 x 25 mm and with 55 mm switch boxes.
Set of 2 stainless-steel countersunk screws 2,9 x 25 mm and plugs 5 x 25 mm are enclosed.